TRELLEBORG seals

Temperature limit: -60 °C - 325 °C
Pressure limit: 200 MPa

Back-up Rings are commonly used to protect seals from the effects of extrusion when pressurised adjacent to a housing gap. A wide range is available to suit all seals and grooves. Usual configurations ...

Temperature limit: -60 °C - 325 °C
Pressure limit: 200 MPa

... are available on request. In addition, special O-Rings can be supplied with their flashline in a specified position on the seal or inspected to stringent criteria, if required.

Temperature limit: -45 °C - 200 °C
Pressure limit: 35 MPa

The original seal design developed to improve the performance of the O-Ring and Back-up ring used in the MIL-G-5514F grooves. The Turcon® Double Delta® II is a double-acting sealing element which is energized by an elastomer ...

Temperature limit: -70 °C - 300 °C
Pressure limit: 20 MPa

A single-acting sealing element comprised of a U-shaped Turcon® ring and metallic energizing finger spring. It offers low friction with no stick-slip, minimal break out force and high wear resistance. Resistant to most liquids and chemicals, ...

Temperature limit: -45 °C - 200 °C
Pressure limit: 60 MPa

The Turcon® VL-Seal® has been developed over the last few years as a new generation, unidirectional rod and piston seal. The design is based on the latest sealing theories and practical experience, tested ...

... spiralling or rolling under severe working conditions. The small elastomer contact area of the Wedgpak® design, results in a slipper seal type performance, with low static and dynamic friction. At the same time, the elastomer ...

Temperature limit: -45 °C - 200 °C
Pressure limit: 50 MPa

Turcon® Dual Piston Ring is typically energised by a stainless steel wave-shaped spring.The characteristics of the seal are very low friction, long service life and a controlled leakage over the rings. The Turcon® Dual ...

Temperature limit: -30 °C - 200 °C

The GAMMA Seal is an axial rotary seal that excludes contamination, moisture and grease. It consists of an elastomer sealing lip contained in a metal carrier. This design copes with arduous static and ...

Temperature limit: -50 °C - 200 °C
Pressure limit: 150,000 Pa

Mechanical Face Seals are a special form of mechanical seals. They are also known under other designations, such as lifetime seals, floating seals, duo cone seals, ...

Temperature limit: -30 °C - 200 °C
Pressure limit: 1 MPa

... within the seal width or beyond the seal base. A successful Radial Oil Seal runs with a thin film of fluid under the sealing lip. The film acts as a lubricant and allows a meniscus to ...