Runway end identification beacon HP2040

for airportLEDcolor

FAA L-802H Civil Helipad Beacon - 36 Flashes per Minute [FPM], 75ms pulse width US Army Helipad Pattern (as per TM 5-811-5) 36 Flashes per Minute, 50ms pulses White (double Peak) – Green - Yellow FAA L-802M Military Helipad Beacon - 17.3 FPM, 100ms pulse width 2 Location beacon modes: Modified ICAO pattern (short [2mS] and long [ 25mS] pulse) - 30 FPM 25 FPM UK CAA and Transport Canada timing compliant 2 Morse beacon modes: 4 - 6 WPM (Words Per Minute): 1, 2 and 3 character code options Rotating (simulated) and flashing beacon modes Provision for an additional 8 custom patterns Available as three or single color units, using high brightness LEDs and advanced micro-electronics to provide a range of pre-programmed and user field-selectable operating modes with on-board switches to enable different maximum light output levels to be set and to enable control which quadrants of light are active Quadrant Control: There may be situations where an operator requires that the beacon is only visible from certain directions (for example, to avoid dazzling pilots or causing a distraction). Usually this would require the operator to fit screening or similar but with the FEC Programmable Location & Identification Beacon this is simply achieved by disabling the relevant array(s) by means of simple switches on the main circuit board. To disable a particular array simply slide the switch to ON (Disable) using the tip of a ball point pen or similar tool. The relevant array(s) will remain permanently disabled in all programming modes until the switch(es) are turned off again. As shipped, all of the arrays are enabled