Grooved seals

Temperature limit: -60 °C - 325 °C
Pressure limit: 200 MPa

Back-up Rings are commonly used to protect seals from the effects of extrusion when pressurised adjacent to a housing gap. A wide range is available to suit all seals and grooves. Usual configurations ...

Temperature limit: -60 °C - 325 °C
Pressure limit: 200 MPa

... are available on request. In addition, special O-Rings can be supplied with their flashline in a specified position on the seal or inspected to stringent criteria, if required.

Temperature limit: -70 °C - 300 °C
Pressure limit: 20 MPa

A single-acting sealing element comprised of a U-shaped Turcon® ring and metallic energizing finger spring. It offers low friction with no stick-slip, minimal break out force and high wear resistance. Resistant to most liquids and chemicals, ...

Temperature limit: -45 °C - 200 °C
Pressure limit: 60 MPa

The Turcon® VL-Seal® has been developed over the last few years as a new generation, unidirectional rod and piston seal. The design is based on the latest sealing theories and practical experience, tested ...

... spiralling or rolling under severe working conditions. The small elastomer contact area of the Wedgpak® design, results in a slipper seal type performance, with low static and dynamic friction. At the same time, the elastomer ...

Temperature limit: -45 °C - 200 °C
Pressure limit: 50 MPa

Turcon® Dual Piston Ring is typically energised by a stainless steel wave-shaped spring.The characteristics of the seal are very low friction, long service life and a controlled leakage over the rings. The Turcon® Dual ...

Temperature limit: -70 °C - 300 °C
Pressure limit: 20 MPa

... friction with no stick-slip, minimized break out force and high wear resistance. Its constrained flange eliminates potential seal rotation and it is resistant to most liquids and chemicals. Unlimited shelf life.

Aerocom Flexijoint PTFE Expansion Joints are designed to compensate for thermal changes, misalignment and isolate vibration in piping systems. These high quality,North American manufactured Expansion Joints are constructed from uniform-walled ...