On-board Power Supply Embedded power supply for AWACS equipment.
Input voltage: 90 V - 264 V
Output voltage: 14, 28 V
Current: 6, 12, 30 A
Solid state lightweight power supply capable of supplying up to 30A at 14V DC or 28V DC for training, maintenance and software updates. 30A @ 14V DC/28V ...
POWERVAMP LTD
Input voltage: 100 V - 230 V
Output voltage: 24 V
Current: 3.5 mA - 30 mA
The 2EL-OBS2-PWR is a power supply for the 2EL-OBS lights. FEATURES Very compact and esthetic design Optimized sealing concept against the intrusion of liquids and dust (IP 67) Dual Power ...
Input voltage: 208 V - 575 V
Output voltage: 28.5 V
Current: 400 A - 2,500 A
FCX solid-state power supplies provide regulated 28.5VDC power with minimal noise. The power supplies are equipped with an adjustable current limiting ...
FCX Systems Inc
Output voltage: 28.5, 56 V
The combined power supply units of ЕАСR series are intended to supply power to the on-board electrical equipment of aircrafts and helicopters during pre-flight preparation ...
SCRs supply of airport lighting circuits at various intensity levels. Specially designed for the supply of circuits which characterized by non-linear loads, devices using LED electronics. The constant ...
IGBT supply of airport lighting circuits at various intensity levels. Specially designed for the supply of circuits which characterized by non-linear loads, devices using LED electronics. The constant ...
Input voltage: 230 V
... disconnection, a relay will command the operation of the secondary obstruction light (slave). The same thing happens if the power supply of the primary obstruction light fails or is not supplied with ...
Input voltage: 230 V
Output voltage: 48 V
... twilight sensor, synchronization, etc. Description The photocell is mounted on the front panel of the controller The power supply controller is equipped with a test switch (this option is for ...
Output voltage: 14, 28 V
Current: 7, 3.5 A
... Operating the wing tip strobes in the alternating mode will provide an accumulated 42 joules of power to each light. When in the simultaneous mode, the accumulated power to each light is 21 joules. In ...
Input voltage: 12 V - 265 V
Output voltage: 12 V
Current: 80, 14, 15 A
... Uninterruptable Power Supply (NM-UPS) is the ideal solution to ensure the continuous power supply for electrical equipment in remote and rough environments or in big ...
... buttons Matching taps on output transformer for improved primary power factor and efficiency. 3, 5 or 7 selectable brightness steps. Remote control selectable between conventional 24/48V DC Multi-wire ...
Input voltage: 115, 230 V
Output voltage: 6 V - 48 V
Current: 1.8 A - 9 A
... RF-radiation 5-year warranty Obelux power supplies are suitable for all Obelux products. Obelux power supplies are available with various operating voltages and for ...
Input voltage: 28 V
... Mechanical dimensions length: 215 mm width: 172 mm height: 44 mm weight: less than 1,2 kg Electrical data power consumption: max. 112 W
Input voltage: 415, 240, 400, 208, 230 V
Current: 2.2 A - 20 A
... filters Solid-state operation with no relays eliminates mechanical failures TKH Airport Solutions CCR 961 supplies precision output levels to power series lighting circuits on airport runways and ...
Output voltage: 12 V
Current: 0.5 A
This small "wall adapter" type power supply is UL rated and provides up to 0.5A of current at 12 Volts DC Use the attached lock fitting to mate to our 12V Gooseneck lamps or remove ...
... and are ready for use. The construction design all flip supply systems leaves these systems very expensive to build against aggressive environmental conditions. That's why most underfloor supply systems ...
... WITH STANDARDS ICAO: Aerodrome Design Manual Part. 5 FAA: AC 150/5345-10 IEC: 61822 AENA: PPT_002-05_13 APLICATTION / USE Switch mode constant current regulator especially designed to power airport ...
Please specify:
Help us improve:
remaining